Machine Set Up; Fitting The Brushes; Fitting The Floor-Tool - Numatic TTB 1840 Mode D'emploi

!

Fitting the brushes

Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
Only use manufacturer supplied brushes.
This machine requires a 400mm brush or a 360mm pad.
Safety gloves are recommended for the changing of used brushes.
Fitting the Floor Tool
The floor-tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor-tool gets snagged, whilst in transit.
Machine Set-Up
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
BEFORE MAKING ANY ADJUSTMENTS
Fig.6
Fig.7
Fig.8
Secure to the carrier using the
two knobs fitted to the floor-tool
carrier (Fig.9) (Fig.9a).
Do not over tighten the retaining
knobs.
Fig 9
Slide the brush / pad under the brush deck (Fig.6).
Fit the brush / pad onto the Nulock drive chuck, twist to lock
the brush / pad in place (Fig.7).
Swing the floor-tool carrier to the side of the machine
(Fig.8).
Note:
It is easier to fit the floor-tool if the weight of the machine is
resting on the brush. Ensure the brush is fitted first.
22
!
Fig 9a