Hose U Bend Clip; Fitting The Floor Tool; Breakaway Floor Tool Feature - Numatic TRG 720/200T Notice Originale

Machine set-up guide
Fitting Dump Hose
Hose U-bend clip
The U-bend in the hose prevents water spillage when the vacuum is switched off.
Refit vacuum hose to the floor tool when finished.
NOTE: DO NOT push the vacuum hose onto the floor tool with the floor tool in the raised position.

Fitting the floor tool

NOTE: Raise floor tool before driving to the cleaning area.
The machine will not operate in reverse with the floor tool lowered.
Lower the floor tool arm by moving the release lever to the upper position (Fig.1).
Break-away floor tool
The floor tool design incorporates a safety knock-off feature, this allows it to safely
disengage from its mounting should it become caught on an obstruction during
forward movement.
Please ensure you do not over tighten the retaining knobs.
Slide floor tool onto bracket.
!
NOTE: MACHINE WILL NOT REVERSE WITH FLOOR TOOL IN THE LOWERED POSITION.
Tighten retaining knobs to finger tight
and attach hose.
7MM
1
Lower the floor tool.
Raise the floor tool.
T (+ 44) 01460 68600
!
9