PREVOST H Serie Manuel De L'opérateur page 192

184 Annexe C –
LISTE ET DESCRIPTION DES CODES D'ANOMALIE (DTC) DE LA TRANSMISSION ALLISON 4
DTC
C1312 Retarder Request Sensor Failed Low
C1313 Retarder Request Sensor Failed High
P0122 Pedal Position Sensor Low Voltage
P0123 Pedal Position Sensor High Voltage
P0218 Transmission Fluid Over Temperature
P0602 TCM Not Programmed
P0610 TCM Vehicle Options (Trans ID) Error
P0613 TCM Processor
P0614 Torque Control Data Mismatch - ECM/TCM
P0634 TCM Internal Temperature Too High
P063E Auto Configuration Throttle Input Not Present
Auto Configuration Engine Coolant Temp Input Not
P063F
Present
P0658 Actuator Supply Voltage 1 (HSD1) Low
P0659 Actuator Supply Voltage 1 (HSD1) High
P0702 Transmission Control System Electrical (TransID)
P0703 Brake Switch Circuit Malfunction
P0708 Transmission Range Sensor Circuit High Input
P070C Transmission Fluid Level Sensor Circuit – Low Input
P070D Transmission Fluid Level Sensor Circuit – High Input
Transmission Fluid Temperature Sensor Circuit
P0711
Performance
P0712 Transmission Fluid Temperature Sensor Circuit Low Input
P0713 Transmission Fluid Temperature Sensor Circuit High Input
P0716 Turbine Speed Sensor Circuit Performance
P0717 Turbine Speed Sensor Circuit No Signal
P0719 Brake Switch ABS Input Low
P071A RELS Input Failed On
P071D General Purpose Input Fault
P0721 Output Speed Sensor Circuit Performance
P0722 Output Speed Sensor Circuit No Signal
P0726 Engine Speed Sensor Circuit Performance
P0727 Engine Speed Sensor Circuit No Signal
th
P0729 Incorrect 6 Gear Ratio
st
P0731 Incorrect 1 Gear ratio
Codes d'anomalie de la transmission Allison
Description
CHECK
Inhibited Operation
TRANS
Description
Light
May inhibit retarder operation if not
No
using J1939 datalink
May inhibit retarder operation if not
No
using J1939 datalink
Use default throttle values. Freezes
No
shift adapts.
Use default throttle values. Freezes
No
shift adapts.
Use hot mode shift schedule. Holds
No fourth range. TCC is inhibited.
Freezes shift adapts.
Yes Lock in Neutral
Yes Use TID A calibration
No All solenoids off
Allows operation only in reverse and
Yes
second range.
Yes SOL OFF (hydraulic default)
Yes Use default throttle values
No None
Yes DNS, SOL OFF (hydraulic default)
Yes DNS, SOL OFF (hydraulic default)
Yes Use TID A calibration
No Neutral to Drive shifts for refuse
packer. TCM inhibits retarder
No
operation if a TPS code is also
active.
Yes Ignore defective strip selector inputs
No None
No None
Yes Use default sump temp
Yes Use default sump temp
Yes Use default sump temp
Yes DNS, Lock in current range
Yes DNS, Lock in current range
No TCM assumes ABS is OFF
Yes Inhibit RELS operation
Yes None
Yes DNS, Lock in current range
Yes DNS, Lock in current range
No Default to turbine speed
No Default to turbine speed
Yes DNS, Attempt 5
Yes DNS, Attempt 2
E
GENERATION
th rd
, then 3
nd th
, then 5