HEADLIGHT BEAM ADJUSTMENT
ESS00079
ELECTRICAL
ESS00080
HEADLIGHT BEAM ADJUSTMENT
1. Place the machine on a level surface.
2. Measure the distance from the floor to the
3. Place the machine from the wall at a distance
4. With a person sitting on the machine, apply
5. Turn the headlight to high beam and check
D
S
D : Distance
6. Adjust:
S Headlight beam (vertically)
Vertical adjustment
Higher
Lower
7. Adjust:
S Headlight beam (horizontally)
Horizontal adjustment
Right
Left
2-27
center of the headlight and place a mark on
the wall equal to distance H from the floor.
D indicated by the chart below.
the parking brake, start the engine and let it
idle.
the headlight projection height on the wall.
The projection should be at the parallel mark
on the wall H to 1/2_ down S from the mark.
If not, adjust the headlight angle.
3.0 m (10 ft)
26 mm (1.0 in)
S : Set range
Turn the adjusting screw 1 coun-
terclockwise.
Turn the adjusting screw 1 clock-
wise.
Turn the adjusting screw 1 coun-
terclockwise.
Turn the adjusting screw 1 clock-
wise.
INSP
ADJ
7.6 m (25 ft)
66 mm (2.6 in)