Publicité
BRAKE
INSPECTION
1. Inspect:
S One way lock 2 1
S Stationary cover 2
S Lever 3
S Spiral gear 4 (lever)
Cracks/wear/damage ! Replace.
Replacement steps:
S Remove the one way lock 2 1 using a thin flat-
head screw driver.
S Remove the washer 2 and stationary cover
3 .
S Replace a damaged part(s) use a new one.
S Reassemble the removed part(s) and reverse
the above steps.
CAUTION:
Always use a new one way lock 2.
2. Inspect:
S Torsion spring 1
Fatigue/damage ! Replace end cover unit.
Inspection steps:
S Check the fatigue of the torsion spring by the
projection mark a on the guide 1 located be-
tween the base marks b on the end cover 2 .
If projection mark a is not in the range be-
tween the base marks b , replace the end cov-
er unit.
3. Inspect:
S Adjusting ratchet 1
Cracks/wear/damage ! Replace.
S Spring 2 (brake cable)
Fatigue/damage ! Replace.
S Brake pad 3 thickness
S Brake disc 4
Bend/cracks/damage ! Replace.
4-30
POWR
TR
Publicité
