Publicité
ELECTRICAL STARTING SYSTEM
5. Measure:
S Brush length a
6. Measure:
S Brush spring pressure
Assembly
1. Before installing the front and rear covers,
2. Make sure the rear cover and front cover are
3. When installing the rear cover assembly,
4. Install:
S Securing bolts (starter motor)
NOTE:
Align the match marks 1 on the bracket with
the match marks 2 on the yoke.
7-23
Out of specification ! Replace.
Brush length limit a :
8.5 mm (0.33 in)
Fatigue/Out of specification ! Replace as a
set.
Brush spring pressure:
800
150 g (28.22
apply bearing grease to the bearings of the
front and rear covers.
fitted with O-rings.
take care not to scratch the brushes.
ELEC
5.30 oz)
Publicité
