Resolution Of Problems Linked To Warning Messages And Device Status Led Is Orange And Flashing - Burkert 8025 Manuel D'utilisation

message possible cause
displayed
"ERROR5" Both "ERROR3" and
"ERROR4".
"ERROR6" Totalizer values defi-
nitely lost.
Both totalizers are
reset.
"ERROR7" Both "ERROR3" and
"ERROR6".
38
recommended action
→
Start the device again.
→
If the message persists,
configure the device
again.
→
If the problem occurs
again, take contact with
the retailer.
→
Start the device again.
→
If the problem occurs
again, take contact with
the retailer.
→
Start the device again.
→
If the message persists,
configure the device
again.
→
If the problem occurs
again, take contact with
the retailer.
English
Type 8025 / SE35, battery powered
Maintenanceandtroubleshooting
message possible cause
displayed
"MEAS. OVF" The rotational fre-
quency of the paddle
wheel is higher than
250 Hz.
9.4.3 resolution of problems linked to
warning messages and device
status lED is orange and flashing
message possible cause
displayed
"WARN. LO" The measured flow rate
has stayed under the
minimum threshold for
the set time delay.
This message appears
when the flow rate
is monitored (see
chap. 8.8.2).
recommended action
→
Check the flow rate in
the pipe.
→
If necessary, adjust the
flow rate.
→
If the problem occurs
again, take contact with
the retailer.
recommended
action
→
Check the flow
rate in the pipe and
its consequences
on the process.
→
If necessary, clean
the flow sensor.