Installation Of The 8025 On The S020 Fitting; Installation Of The Se35 Electronic Module On The Sensor-Fitting; Description Of The Electronic Board Connections - Burkert 8025 Manuel D'utilisation

Masquer les pouces Voir aussi pour 8025:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.2.2
installation of the 8025 on the S020
fitting
Insert nut 3 on the fitting 5.
Engage snap ring 2 into groove 4.
Check that seal 6 is fitted on the flow sensor.
Slowly engage device 1 into the fitting.
If the mounting is correctly done the device cannot
turn around anymore.
Hand lock the assembly with nut 3.
Fig. 6 :
Installation of 8025 on the S020 fitting
7.2.3
installation of the SE35 electronic
module on the sensor-fitting
Mount electronic module 2 in sensor-
fitting 1.
Secure with a 30° clockwise turn.
Tighten lateral screw(s) 3 to lock
the electronic module and the
sensor-fitting.
Fig. 7 :

Installation of the SE35 electronic module on the sensor-fitting

14
6
3
English
7.3
Description of the electronic
board connections
1
2
3
4
5
Connector of the
flow sensor
2
Terminal block:
L+: positive power supply (red wire) (factory wired)
L-: negative power supply (black wire) (factory wired)
1
Fig. 8 :
Electronic board connections
Type 8025 / SE35, battery powered
Installation
Terminal block
ON <> OFF
L+ NC L- FE P+ P-
LOCK
Unused connector

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Se35

Table des Matières