Instructions For Autoclave Shipping - Tecno-gaz Europa B xp Mode D'emploi

16 – INSTRUCTION FOR AUTOCLAVE SHIPPING
In case the autoclave must be shipped for repairs, controls, reactivation, revisions, validations follow the
obligatory indications below:
1 – Use the original packaging; if this is no longer in your possession, use adequate packaging. The
merchandise travels at risk to the sender.
2 – Ship only the autoclave, always removing trays and tray carrier.
3 – Carefully clean the sterilization chamber and autoclave in general before shipping. In case it arrives dirty or
with residual the autoclave with be returned without being repaired, or it will be put through a cleansing action
and disinfection.
4 – Always empty the clean water tank through the attachment located on the back of the autoclave (fig. 10
pos.3).
5 – Always empty the used water tank through the attachment located on the back of the autoclave (fig, 10
pos. 4).
FIGURE 10
Frontal view 1.3
Pos. 3
6 – Indicate by letter and insert in the package a document which indicates precisely the irregularity or service
desired.
7 - Ship at your expense, otherwise you will be billed for shipping.
ATTENTION
All non original packaging which arrives will be disposed of.
Autoclave will be returned with new and original packing to insure maximum protection for your
autoclave during shipping.
Cost of packaging will be charged to client.
71 DXBA408 Rev_14