Siemens SINUMERIK 840D sl Manuel De Mise En Service page 760

Configuration du système
2.3 Réglages personnalisés pour le démarrage
# Filtering Concurrent Keys
# =========================
# Definition and selection of function keys (buttons) which shall not be
# pushed in parallel or at the same time (function keys F1-F12 and
# additional hardkeys).
# If more of these buttons are pushed at the same time, the system removes the
# code of these buttons except the code of the button which was pushed first.
# This function of the keyboard-driver is activated by ConcurrentKeyEnable.
# ConcurrentKeyMask holds a BIT-Pattern for a max of 17 function keys, which
# must not be pushed simultaneously (concurrently). If bit-n is set in
# ConcurrentKeyMask, the corresponding button is supervised.
# The following 17 function keys are implemented:
# F1
# F2
# F3
# F4
# F5
# F6
# F7
# F8
# F9
# F10
# F11
# F12
# PAGE-UP (NUMLOCK) Alarm Hardkey on Operator Panel
# PAGE-DOWN (NUMLOCK) Tool Management Hardkey on Operator Panel
# HOME (NUMLOCK) Program Manager Hardkey on Operator Panel
# END (NUMLOCK) Program Hardkey on Operator Panel
# CURSOR-DOWN (NUMLOCK) Alarm Hardkey on Operator Panel
Remarque
Etendue des touches
Seules les touches déjà définies dans le fichier system.ini peuvent être validées.
Aucune touche supplémentaire ne peut être définie pour le filtrage.
Voir aussi
ServiceCenter Users : Paramètres pour les utilisateurs (Page 10)
46
Manuel de mise en service, 03/2010, 6FC5397-1DP10-5DA0
Logiciel de base PCU (IM8)