TOHATSU MFS 40A Manuel De L'utilisateur page 73

72
INSPECTION AND MAINTENANCE
tal drop or fall of outboard motor could
lead to severe personal injury.
Be sure to lock outboard motor if it is
tilted up, or accidental fall of outboard
motor could lead to severe personal
injury.
Do not go under outboard motor tilted
up and locked, or accidental fall of out-
board motor could lead to severe per-
sonal injury.
1. Tilt down the outboard motor.
2. Remove the oil plugs (lower and
upper), and completely drain the gear
oil into a pan.
3. Insert the oil tube nozzle into the lower
oil plug hole, and fill with gear oil by
squeezing the oil tube until oil flows out
of the upper plug hole.
ENOW00927-0
CAUTION
Over fill the gear oil until bubble is disap-
peared to remove the air.
4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
ENOW00095-0
Do not reuse oil plug gasket. Always use
new gasket and tighten oil plug properly to
prevent entry of water into lower unit.
ENOF00927-0
ENOW00928-0
Wipe off gear oil well immediately if spilled
and dispose of it in accordance with local
ENOF00100-A
CAUTION
ENOF00101-A
CAUTION