Engine Operation; Before Starting; Fuel Feeding - TOHATSU MFS 40A Manuel De L'utilisateur

36

ENGINE OPERATION

ENOM00042-0

Before starting

ENOW00022-A
CAUTION
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before starting engine. (To
properly fill the engine with oil follow the
instructions. See page 63)
ENOW00027-A
CAUTION
Before starting engine for the first time
after reassembling engine or off-season
storage, disconnect stop switch lock and
crank approximately 10 times in order to
prime the oil pump.
ENOM00044-A

1. Fuel feeding

1. Full open the air vent screw on the tank
cap.
2. Loosen the tank cap until contacts the
tab lock and release internal pressure
completely. After that, close the tank
cap until two click sound is heard.
3. Connect the fuel connector to the
engine and fuel tank.
ENOF00850-0
4. Squeeze primer bulb until it becomes
stiff to feed fuel to vapor separator.
Direct arrow mark upward when prim-
ing.
1. Engine side
2. Fuel tank side
Do not squeeze primer bulb with engine
ENOF00860-A
ENOF00861-A
1
2
ENOF00862-0