Before First Use; Basic Operation; Reverse Function; Overheat Protection - ADE KA 1801 Mode D'emploi

Before first use

Before first use
1. Carefully unpack the mincer and remove all packaging materials.
2. Check that the delivery is complete (see chapter "At a glance").
3. Check whether the mincer or its individual parts have any damage. If this is the case,
do not use the mincer. In this case, contact the dealer where you bought the device.
4. Before rst use, clean all parts of the mincer as described in the chapter "Cleaning".

Basic operation

NOTE on material damage
− Operate the mincer for a maximum of 5 minutes at a time. After that,
allow the mincer to cool down for approx. 10 minutes.
Before you can use the mincer, you must assemble it for the desired purpose. More
information can be found in the chapters "Making mince", "Making sausages", "Kebbe",
and "Making shortbread biscuits".
This chapter describes the basic operation.
1. Place the mincer on a clean and flat surface.
2. Unwind the power cord completely and insert the power plug into a mains outlet.
3. Put the mode selector switch in position 1 or 2 to turn on the device.
4. To turn off, put the mode selector switch back in the switch position .
5. Unplug the power cord from the mains outlet after use.
6. Clean the mincer and the accessories used.
When the cross blade blunts, you will have to replace it. Replacement cross
blades can be reordered for a fee. Please email us at our service address:
service@ade-germany.de

Reverse function

With this function, the screw turns backwards, making it easier for you to force out
meat that has been stuck in the filling tube upwards.
− Put the mode selector switch in position R.
Pay attention to the following:
This function helps you release jammed meat. Do not use it for other purposes.
The mode selector switch is spring-loaded when you turn it to R. As soon as you
release the switch, the device will switch off.

Overheat protection

This mincer has a built-in overheat protection. If the overheat protection triggers, the
device will switch off immediately during use.
30
Mincer KA 1801