Step 3 Connect Water Line; Step 4 Connect Power - Monogram ZIK30GNNII Instructions D'installation

WARNING
These appliances are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions for
securing the appliance with the anti-tip system.
BRACKET
Inside Top Face of bracket should be installed at
Mark (within slots, placement) stud and anchor
positions on brackets.
Slot
Secure bracket using combination of studs &
anchors.
At least 1 stud must be engaged. However, please
engage as many studs as possible within the
enclosure. A minimum of three fasteners should be
used for proper installation.
31-1000169 Rev. 1
Installation Instructions
Tip Over Hazard.
80"

STEP 3 CONNECT WATER LINE

Connect to potable water supply
WARNING
only.
Position appliance in front of enclosure.
Locate and bring tubing to the front of the cabinet.
Turn the water on to flush debris from line. Run about
shut off water.
If needed cut the tubing to the proper length so it can
be attached to the water valve.
Copper Tubing:
copper tubing. Insert tube into the union fitting on the
unit and tighten nut to union.
Turn on the water to check for leaks.
SmartConnect™ Tubing:
Insert the end of the tubing into the refrigerator
connection. Tighten the compression nut until it is just
hand-tight.
Tighten one additional turn with a wrench.
Overtightening can cause leaks!
Turn on the water to check for leaks.

STEP 4 CONNECT POWER

Plug the power cord into the socket.
Check to make sure power to refrigerator is on by
opening the ice drawer (FF door will be banded shut)
to see if interior lights are on.
The temperature controls are preset at 37°F for the
fresh food section and 0°F in both the freezer drawer
and customizable drawer.
Allow 24 hours to stabilize before making
adjustments.
13
Water
Line Hole