Installation Instructions - Standard Installation
STEP 11 CONNECT WATER
SUPPLY
Connect to potable water supply
WARNING
only.
AVERTISSEMENT
Raccordez l'appareil à une
alimentation d'eau potable seulement.
ADVERTENCIA
Realice la conexión a un
suministro de agua potable únicamente.
• Locate and bring tubing to the front of the cabinet.
• Turn the water on to
flush debris from line.
Run about a quart of
water through tubing
into a bucket, then
shut off water.
Copper Tubing:
• Slip a 1/4" nut and
ferrule (provided)
over both ends of the
copper tubing. Insert
tube into the union
fitting on the unit and
tighten nut to union.
• Turn on the water to check for leaks.
SmartConnect
Tubing:
™
NOTE: The only Monogram-approved plastic tubing is
supplied in the SmartConnect
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types of
plastic may crack or rupture with age and cause water
damage to your home.
• Insert the molded end of the tubing into the
refrigerator connection. Tighten the compression nut
until it is just hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not
interfere with drawer closing or toekick installation.
House
Refrigerator
Water Supply
Water Supply
Refrigerator Tubing kits.
™
STEP 12 CONNECT POWER
• Check to be sure the power cord is plugged into the
receptacle.
Electrical Outlet
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights are on.
• The temperature controls are preset at 37°F (2.78°C)
for the fresh food section and 0°F (-17.78°C) for the
freezer.
• Allow 24 hours to stabilize before making
adjustments.
20
31-49142 Rev. 2