Step 8 Install Toekick And Vent; Step 9 Reverse Door Swing - Monogram ZIK30GNNII Instructions D'installation

STEP 8 INSTALL TOEKICK AND
VENT
Locate the toekick, vent and screws (removed
earlier).
A custom toekick can be installed to match or
complement the surrounding cabinetry. Use the
supplied toekick as a template.
Reinstall the vent using the screws removed earlier.
Reinstall the toekick .
Supplied Toekick

STEP 9 REVERSE DOOR SWING

(if needed)
Skip this step if door swing is satisfactory.
WARNING
Follow all steps when reversing
the door swing. Failure to follow these instructions,
leaving off parts, or overtightening screws, can
lead to the door falling off and result in injury and
property damage.
1. Open the fresh food door.
WARNING
Point Hazard
This next step is important for safe handling of an
unloaded hinge. Do not skip step 2.
2. Release the hinge springs by using a Torx T-20
wrench to loosen the Torx screw from | to 0 on both
hinges. Close the door.
31-1000169 Rev. 1
Installation Instructions
Vent Holes
Door Hinge Pinch
STEP 9 REVERSE DOOR SWING
(if needed) (cont.)
per hinge that secure the door to the refrigerator.
Have someone hold the door while removing these
screws to keep the door from falling.
Screws
remove the 2 screws per hinge that secure the hinge
to the refrigerator cabinet.
Screws
5. Remove the trim and hinge pocket from the top of
the refrigerator and install on the opposite sides.
6. Remove the trim and hinge pocket from the bottom
of the fresh food compartment. Remove the control
panel and gently place in the FZ drawer.
Control Panel
7. Reinstall the control panel.
8. The hinges will be reinstalled in opposite corners.
The hinge from the top will be turned over
and installed at the bottom of the fresh food
compartment. The hinge from the bottom will be
turned over and installed at the top of the fresh food
compartment.
Top Hinge
9. Install the screws on the fresh food compartment
cabinet in all 4 places. Screw them in about halfway.
Screws
15
Bottom Hinge
Slots for
Tabs