Step 9 Install Grille Panel; Step 10. Install 1/4" Framed Panels - Monogram ZIC360NNRH Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation Instructions - Standard Installation

STEP 9 INSTALL GRILLE PANEL

• Raise the access panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal baker panel and into the
trim.
STEP 10 INSTALL 1/4" (0.63 cm)FRAMED PANELS
Right hand models shown. Use the same instructions for left hand models.
IF YOU ARE INSTALLING OVERLAY PANELS, GO TO STEP 10A.
Use rear holes to secure optional
ZKLN kit handle (not shown)
Install door and drawer panels:
• Open door to 90°.
• Remove 4 screws holding trim, lift off trim. Retain
screws.
• Slide framed panel into the door trim.
31-1000452 Rev. 1
Use front holes
to secure trim
Optional visor handle shown from
• If necessary, tap with a wood block until the panel slips
under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
kit ZKLN
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original
screws in the FRONT screw holes.
• Follow the same procedures to install the drawer
panel.
19

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zics360nnrhZics360nnlhZisb420dniiZic360nnlh

Table des Matières