Step 7 Alternate Anti-Tip Procedure; Step 8 Adjust Door Swing - Monogram ZIC360NNRH Instructions D'installation

Installation Instructions - Standard Installation
STEP 7 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent
tipping.
If the anti-tip bracket cannot be used, this alternate
procedure may be used to secure the refrigerator
against tip-over
• Raise the grille panel to access case trim.
• Use a 3/16" bit to drill four evenly spaced clearance
holes through the metal top case trim.
Top Case Trim
Install four 1-1/2" drywall screws through
trim and into soffit or 3/4" min. wood brace
• Use a 1/16" bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4" min. wood
brace. The brace spanning the enclosure must be
securely fastened to cabinets on both sides.
• Install four, 1-1/2" (3.81 cm) drywall screws into the
pilot holes.
• If no soffit above the unit, drill screws into adjacent
cabinets through the side case trim.
Drive screws through case
trim into adjacent cabinets
3/4" Min.
Side View Top
Case Trim
Raise grille panel to
stop position
18

STEP 8 ADJUST DOOR SWING

NOTE: This refrigerator has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to
a 90° opening. A 130° door swing is available for
standard installation only. If used for flush installation,
damage will occur to wood panels. Skip this step if
door opening is satisfactory for your installation
situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
Remove wire cover trim
• Use pliers to unscrew door stop and reinstall into the
90° or 130° position.
Pin Location
for 90°
Door Swing
• Reinstall the wire cover trim.
screws
Pin Location for
130° Door Swing
Pin Location as
Shipped for 115°
Door Swing
31-1000452 Rev. 1