Step 1 Remove Packaging - Monogram ZIK30GNNII Instructions D'installation

STEP 1 REMOVE PACKAGING

WARNING
This appliance is top heavy. Use extreme caution
with moving to prevent tipping over which could
result in death or serious injury.
Cut bands and tape on the top and bottom
of packaging with a utility knife.
Unfold the cardboard seams and remove the top
of the packaging.
Slide the remainder of the box off of the appliance. You
can use a box cutter to cut the remaining cardboard
being VERY CAREFUL not to scratch
the appliance.
Remove the Styrofoam supports from around the unit.
DO NOT remove door band or lower EPS banded part
until unit is ready to go into enclosure.
Cut EPS skid at the sides near the front from the back
of the unit.
Push unit forward & remove rear portion of the EPS
skid.
Carefully lower rear onto the floor.
Lean unit back slightly & remove front portion of the
EPS skid.
Discard all unused packaging materials appropriately.
The unit can now be moved using an appliance hand
truck or rolled on a properly protected floor by 2
people.
Leave any protective film on the refrigerator until
installation is complete.
Installation Instructions
Tip Over Hazard.
12
31-1000169 Rev. 1