Datcom; Usb - Fronius Primo 3.0-1 Instructions De Service

DATCOM

Checking data communications, entering the inverter number, protocol settings
Setting range
Status
Indicates data communication is taking place via Fronius Solar Net or that a
data communications error has occurred
Inverter number
Sets the number (= address) of the inverter in a system with several inverters
Setting range
Factory setting
IMPORTANT! If a number of inverters are linked together in a data communic-
ations system, assign a unique address to each one.
Protocol type
Specifies the communications protocol to be used to transfer the data:
Setting range
Factory setting
* The protocol type "Interface" only functions when there is no Datamanager
card in the inverter. All Fronius Datamanager cards should be removed from
the inverter.

USB

Running firmware updates or saving detailed information from the inverter to the
USB flash drive
Setting range
Safely remove hardware
To remove a USB flash drive from the USB A socket on the plug-in data commu-
nications card without losing any data.
The USB flash drive can be removed:
-
-
Software update
To update the inverter firmware using a USB flash drive.
30
WiFi Access Point
[not available]
Displayed if there is no system monitoring present on
the inverter.
Status / inverter number / protocol type
00 - 99 (00 = inverter address 100)
01
Solar Net / Interface *
Fronius Solar Net
Safely remove hardware / Software update / Logging in-
terval
If the OK message appears
when the "Data transfer" LED stops flashing or comes on steady