Panasonic SD-B2510 Mode D'emploi Et Recettes page 17

Problem
Can frozen fruits be used?
When making jam, can we
use fruits are pickled in
alcohol?
The fruit has collapsed when
making compote.
I can smell burning while the
bread is baking.
Smoke is coming out of the
steam vent.
The kneading blade rattles.
Dough leaks out from
bottom of the bread pan.
"1" appears on the display and
operation has been stopped.
"H01", "H02" appears on the
display.
"U50" appears on the display.
EN OI6 0107.indd 17
During or after cooking
z It can be used for only jam and compote.
z Do not use them. The quality is not satisfactory.
z The cooking time was too long. The fruit may have been over ripe.
Puzzle
z Ingredients may have been spilt on the heating element.
→
Sometimes a little flour, raisins or other ingredients may be flicked out of the bread pan during
mixing. Simply wipe the heating element gently after baking once the machine has cooled down.
→
Remove the bread pan from the main unit to place ingredients.
z This is because the kneading blade fits loosely on the kneading mounting shaft. (This is not a fault.)
z A small amount of dough will escape through the ventilation holes (so that it does not stop the
rotating parts from rotating). This is not a fault, but check occasionally that the kneading mounting
shaft rotate properly.
→
If the kneading mounting shaft does not rotate when the kneading blade is attached, you will need
to replace the kneading mounting shaft unit. (Consult the place of purchase or Panasonic service
centre.)
(Bottom of bread pan)
Ventilation holes (4 in total) Kneading mounting shaft
Display exception
z When the power supply to machine is interrupted for a certain time, the display shows "1" after
recovered. (It is standby mode and machine could not continue the program.)
→
Remove the bread, dough or ingredients and start again using new ingredients.
z The display indicates a problem with the machine.
→
Consult the place of purchase or a Panasonic service centre.
z The machine is hot (above 40 °C ). This may occur with repeated use.
→
Allow the machine to cool down to below 40°C before using it again (U50 will disappear).
Cause and Action
Kneading
mounting shaft
Kneading
mounting shaft unit
Part no. ADA29E226
GB17
2021/4/12 19:07:13