Bluetooth Settings; Application And Function Of Cif Module - Wilo Stratos GIGA2.0-I Notice De Montage Et De Mise En Service

en
13.8 Application and function of CIF
module
234
Communication interfaces: Setting and function
...External interfaces
Analogue input (AI3) function
Not configured, 0 – 10 V
Function analogue input (AI4)
Not configured, 0 – 10 V
Wilo Net settings
ID0, termination: switched off

Bluetooth settings

Wilo-Connect module plugged
Fig. 87: Bluetooth interface setting
The following settings are possible (Fig. 88):
ƒ
Bluetooth The Bluetooth signal of the Wilo-Smart Connect Module BT can be
switched on and off.
ƒ
Connectable It is permitted to establish a Bluetooth connection between the pump
and a mobile end device with Wilo-Smart Connect app (ON).
It is not permitted to establish a Bluetooth connection between the pump and a
mobile end device with Wilo-Smart Connect app (OFF).
ƒ
Dynamic PIN When a connection to the pump is established with a mobile end
device using the Wilo-Smart Connect app, a PIN appears in the display. This PIN
must be entered into the app to establish a connection.
Two PINs are available for selection via "Dynamic PIN".
ƒ
OFF Each time a connection is established, the last four digits of the S/N serial
number of the Wilo-Smart Connect Module BT are shown in the display. The S/N
number is printed on the rating plate of the Wilo-Smart Connect Module BT. This is
called a "static PIN".
ƒ
ON A new PIN is always dynamically generated and shown in the display each time
a connection is established.
Fig. 88: Bluetooth interface
If the menu item "Bluetooth setting" does not appear even though the Wilo-Smart
Connect Module BT is plugged in, check the LED display on the module. Analyse the
fault using the user manual for the Wilo-Smart Connect Module BT.
NOTICE
The menu "Bluetooth setting" only appears in English.
Depending on the inserted CIF module type, an associated settings menu is displayed in
the menu:
Setting the parameters
of the Wilo Connect Module
"Bluetooth".
WILO SE 2021-12