Spare Parts; Factory Settings - Wilo Stratos GIGA Série Notice De Montage Et De Mise En Service

12

Spare parts

13

Factory settings

Installation and operating instructions Wilo-Stratos GIGA, Stratos GIGA-D, Stratos GIGA B
Spare parts may be ordered via a local specialist and/or Wilo customer
service.
When ordering spare parts, make sure to state all the information
given on the pump and drive rating plates (for the pump rating plate,
see Fig. 11, Item 1, for the drive rating plate, see Fig. 12, Item 3). This
helps prevent return queries and incorrect orders.
CAUTION! Risk of property damage!
Trouble-free pump operation can only be guaranteed when origi-
nal spare parts are used.
• Only use original Wilo spare parts.
• Each component is identified in the table below.
• Information to be provided when ordering spare parts:
• Spare part number
• Name/description of the spare part
• All data on the pump and drive rating plates
NOTE:
For a list of original spare parts, see the Wilo spare parts documenta-
tion (www.wilo.com). The item numbers on the exploded view draw-
ing (Fig. 7) are intended as orientation and to provide a list of the
pump components (see list "Tab. 2: Arrangement of the main compo-
nents" on page 74). These item numbers are not to be used to order
spare parts.
For the factory settings, see Tab. 13 below.
Menu Designation
no.
1.0.0.0 Setpoints
2.0.0.0 Control mode
3.0.0.0 p-v gradient
2.3.3.0 Pump
4.3.1.0 Base-load pump
5.1.1.0 Operating mode
5.1.3.2 Internal/external pump
cycling
5.1.3.3 Pump cycling time interval
5.1.4.0 Pump enabled/disabled
5.1.5.0 SSM
5.1.6.0 SBM
5.1.7.0 External off
5.3.2.0 IN1 (value range)
5.4.1.0 IN2 active/inactive
5.4.2.0 IN2 (value range)
5.5.0.0 PID parameter
5.6.1.0 HV/AC
5.6.2.0 Emergency operation speed
5.6.3.0 Auto reset time
5.7.1.0 Display orientation
5.7.2.0 Pressure value correction
English
Factory-configured values
• Controller:
approx. 60 % of n pump
max
• p-c:
approx. 50 % of H pump
max
• p-v:
approx. 50 % of H pump
max
p-c activated
Lowest value
ON
MA
Main/standby operation
Internal
24 h
Enabled
Collective fault signal
Collective run signal
Collective external off
0–10 V active
OFF
0–10 V
See chapter 9.4 "Setting the con-
trol mode" on page 108
HV
approx. 60 % of n pump
max
300 s
Display on original orientation
Active
125