Maintenance Tasks; Intended Use And Misuse; Intended Use; Misuse - Wilo Stratos GIGA2.0-I Notice De Montage Et De Mise En Service

en
2.6

Maintenance tasks

3

Intended use and misuse

3.1

Intended use

3.2

Misuse

144
Intended use and misuse
ƒ
Wear the following protective equipment:
–
Sealed safety goggles
–
Safety shoes
–
Safety gloves for protection against cuts
ƒ
Locally applicable laws and regulations on work safety and accident prevention
must be complied with.
ƒ
The procedure described in the installation and operating instructions for shutting
down the product/unit must be strictly observed.
ƒ
Only original parts from the manufacturer may be used for maintenance and re-
pairs. The use of any non-original parts releases the manufacturer from any liabil-
ity.
ƒ
Disconnect the device from the mains and secure it against being switched on
again without authorisation.
ƒ
All rotating parts must be at a standstill.
ƒ
Close the gate valve in the inlet and in the pressure pipe.
ƒ
Collect any leakage of fluid and operating fluid immediately and dispose of it ac-
cording to the locally applicable guidelines.
ƒ
Store tools at the designated locations.
ƒ
After completing work, reattach all safety and monitoring devices and check that
they function properly.
The glanded pumps of the Stratos GIGA2.0 series are intended for use as circulators in
building services.
They may be used for:
ƒ
Hot-water heating systems
ƒ
Cooling and cold water circulation systems
ƒ
Industrial circulation systems
ƒ
Heat carrier circuits
Installation within a building:
Glanded pumps are to be installed in dry, well-ventilated, frost-proof rooms.
Installation outside a building (outdoor installation)
ƒ
Observe permissible environmental conditions and protection class.
ƒ
Install the pump in a housing as weather protection. Observe permissible ambient
temperatures (see "Technical data" [} 148] table).
ƒ
Protect the pump against the effects of weather, for example, direct sunlight, rain
and snow.
ƒ
Protect the pump so that the condensate drain openings remain free of dirt.
ƒ
Take suitable measures to prevent the formation of condensation water.
Intended use includes compliance with these instructions as well as the information and
markings on the pump.
Any use beyond the intended use is considered misuse and will result in the loss of all li-
ability claims.
The operational reliability of the supplied product is only guaranteed for intended use in
accordance with chapter "Intended use" of the installation and operating instructions.
The limit values must not fall below or exceed those values specified in the catalogue/
data sheet.
WILO SE 2021-12