The Emergency Stop Functions; Emergency Stop - Roco multiZENTRALEPRO Manuel

See the operating manual for the functions which are available for your locomotive.
You switch the locomotive light on or off using the "Light /OK" key. The star " " at the bottom right of the
▪
display lights up to confirm that the locomotive lighting is switched on.
On

2.4 The Emergency Stop Functions

When a situation becomes dangerous: You can use the "STOP" key at any time to prevent a more serious
calamity immediately. In order to avoid shutting down the entire system however, you can use the "selective
locomotive stop" function to stop only the locomotive selected and displayed.
To save battery life, the multiMAUS
be set in menu 3.7, page 78). This action disconnects the entire system from the mains power supply (factory
setting) and causes the yellow LED on the multiZENTRALE
If you are switching the multiMAUS
"STOP" symbol flashes. Simply press the "STOP" key to restart train operation. The yellow LED stops flashing
on the multiZENTRALE
The multiZENTRALE
PRO
"Connect" key to disconnect the power supply to the system. Pressing the same key again switches the system
back on.

2.4.1 Emergency stop

Press the "STOP" key to sever the voltage at the track at once. The STOP symbol then appears in the display
and the yellow LED flashes at the multiZENTRALE
voltage again.
Stop
switches itself off if not used for a certain amount of time (value can
PRO
back on ("Light /OK" key), the last used locomotive is displayed and the
PRO
and the green LED once again depicts a steady light.
PRO
offers another option for an emergency stop. In case of an emergency, press the white
PRO
Off
to flash.
PRO
. Press the "STOP" key again to supply the system with
Driving
57