Roco multiZENTRALEPRO Manuel page 76

3.2.4 The multiMAUS
calling up the menu item using the "arrow keys."
To block an area, you will need to enter a code which is comprised of 4 numbers (no letters!). The
password is then always requested when you wish to call up a protected area of the multiMAUS
Factory setting: NONE
"DISABLE MENU": The three main menus cannot be called up;
▪
"DISABLE PRG-MENU": The quick-programming mode is also blocked;
▪
"DISABLE LIB-PRG-MENU": All changes to the locomotive library are also prevented in addition to
▪
both items mentioned above.
Each input has to be confirmed by pressing the "Light /OK" key.
3.3 "RESET"
The multiMAUS PRO
just completely but also partially.
3.3.1 "CANCEL" can be regarded as the emergency exit from this menu item.
3.3.2 When the "SETTINGS" are reset, all entries in the "Settings" menu are reset to factory settings. The
locomotive library remains intact. If calibration has been performed (see 3.3.7), it will have to be re-
peated after the reset.
3.3.3 Select this sub-item if you wish to delete the "LOCO LIBRARY."
3.3.4 Selecting "ROUTES" deletes all saved routes.
3.3.5 Select "DOUBLE HEADING" to delete all created Double Headings.
3.3.6 You can use "FACTORY RESET" to reset your multiMAUS
entries made are deleted.
With the items listed above, all you have to do is press the "Light /OK" key. You are then automatically returned
to the "RESET" menu item.
3.3.7 You will not normally have to calibrate the multiMAUS
the event of extreme temperature variations, the controller may need to be re-adjusted, e.g. if a loco-
motive travels in the zero position. To do so, use the "CALIBRATION" menu and proceed as follows:
The first screen you see is the "START?" screen. To confirm, press the "Light /OK" key. "LEFT"
▪
appears on the display screen.
Turn the controller to the left as far as it will go. To confirm, press the "Light /OK" key. "MIDDLE"
▪
appears on the display screen.
Turn the controller to the middle (zero position) and confirm by pressing the "Light /OK" key.
▪
"RIGHT" appears on the display screen.
Turn the controller to the right as far as it will go. Once you have confirmed by pressing the "Light /
▪
OK" key, you return to the start level "RESET."
If the multiMAUS
PRO
the unit to the factory setting:
Press "Shift" and "MENU" simultaneously and press "Light /OK" briefly. The text "RESET ALL?" is displayed.
Confirm the reset with "Light /OK" and the multiMAUS
Please note: This reset deletes the entire locomotive library.
3.4 "STOPMODE"
In the event of an emergency, press the "STOP" key during drive mode to trigger an immediate emergency stop.
You determine the exact effect of the emergency stop in menu item "STOPMODE."
3.4.1 "STOPKEY": Use this menu option to define whether pressing the "STOP" key disconnects the entire
system from the mains power supply ("DISABLE VOLTAGE") or whether this only stops the locomo-
76
76
has "CHILD LOCK" which can be set tomultiple levels and can be activated after
PRO
is a particularly user-friendly digital controller and can be reset to the factory settings, not
no longer responds to keyboard commands, use the following key combination to reset
PRO completely to the original status. Any
as this is performed on delivery. However, in
PRO
is reset and restarted.
PRO
.
PRO