Locomotive Address Mode; Driving And Functions - Roco multiZENTRALEPRO Manuel

2.2.3 Locomotive Address Mode

The multiMAUS
PRO
ing the decoder address only. The display screen shows the locomotive address
with the letter "L" before it (in this case, locomotive address 36), the locomotive
symbol and all the selected functions.
You can select another locomotive (address) in two different ways:
using the "arrow keys,"
▪
directly, by entering the number with the function keys after having pressed the "shift" and the "Light /OK"
▪
keys at the same time.
Changes to the speed steps can either be made in the "LOCO" > "EDIT" menu (see Part 3 "Menu functions")
or using the key combination "MENU" and one of the "arrow keys." You make the switch using one of the arrow
keys. To return to locomotive address mode, press the "STOP" key.
Information on how to program a new locomotive address using CV1 can be found in chapter 2.8, page 64.

2.3 Driving and Functions

If you have selected a locomotive from the library or are directly using the locomotive address, it is immediately
ready to drive. You can determine the direction of travel and the speed by turning the large controller. Both the
direction of travel and a standstill are shown on the display screen above the locomotive name or locomotive
address.
If the locomotive is at a standstill (display "II"), the last direction of travel is also shown. Thus it is easy to
▪
discern whether the locomotive lighting is switched on correctly, i.e. white light for the front of the train, red
light at the rear.
Backwards
If another multiMAUS
flashes. Please read Chapter 5.3 "Connecting Several Controllers" on page 83 for additional information.
The locomotive functions, e.g. the noises of a sound locomotive, are activated using the "function keys."
▪
You can trigger the first 10 functions directly by pressing the corresponding keys. For functions F11 –F20 you
must press the respective function key together with the "Shift" key. The display shows the activated
functions.
In the figures above functions F1 and F4 are shown as examples. You can check the activated functions of the
second level (F11 –F20) by pressing the "shift" key.
In the following figure, F12 and F20 are activated. The arrow " " stands for the multiplier of tens, i.e. is
interpreted as "1" for F11 –F 19 and as "2" for F20.
56
56
also gives you the option of controlling your locomotives us-
Standstill
, multiMAUS, Lokmaus, or PC is used to control a locomotive, the locomotive symbol
PRO
Forwards