Roco multiZENTRALEPRO Manuel page 71

1.4 "SEARCH"
This could be one of the most important functions of your multiMAUS
a locomotive address to the corresponding locomotive in the library.
Simply enter a locomotive address using the "function keys" and the multiMAUS
locomotive in the library.
Press the "Light /OK" key to confirm the entry. The multiMAUS
▪
display the assigned locomotive.
If the multiMAUS PRO does not find the corresponding locomotive for the address, "LOCO NOT FOUND" ap-
pears in the display. You can use the "STOP" or "Light /OK" key to return to the start level "SEARCH."
1.5 "SEND"
1.6 "RECEIVE"
You require both of these menu items when you wish to transfer the locomotive library from one multiMAUS
to another multiMAUS
PRO
"SEND" and the other multiMAUS
first.
You start the transmission by pressing the "Light /OK" key on the transmitting multiMAUS
fer is complete, the receiver multiMAUS
level "SEND."
1.7 "MODE"
You can either control a locomotive from library mode as set in the factory or simply using the locomotive ad-
dress. You can select which of the settings you prefer using this menu item.
You select the respective mode using one of the "arrow keys." The modes are displayed in scrolling text.
To confirm, press the "Light /OK" key. You return to the start level "MODE."
▪
(or several multiMAUS devices). To do so, you set the transmitting multiMAUS
or multiMAUS devices to "RECEIVE." The receiver units must be activated
PRO
is in library mode, the transmitting multiMAUS
PRO
PRO . You can use this menu item to assign
PRO will find the corresponding
PRO returns directly to locomotive mode and
. When the trans-
PRO
PRO
PRO
to
PRO
is at the start
71