Roco multiZENTRALEPRO Manuel page 77

tives ("EMERGENCY STOP"). Use the arrow keys to make a selection and confirm with "Light /OK."
Factory setting: DISABLE VOLTAGE
You can still trigger a "selective emergency stop" that only affects the selected locomotive in spite of
this setting. See page 57 for additional details.
3.4.2 "RADIO INTERRUPTION": If the multiMAUS
RALE or has not been used for some time, the unit switches off automatically (set this time with
PRO
menu item 3.7.1). You have to options for avoiding system accidents:
"DISABLE VOLTAGE" disconnects the entire system from the mains power supply.
▪
"EMERGENCY STOP" stops all running trains without turning the mains power supply off.
▪
"NONE" means that all functions continue if the multiMAUS
▪
Factory setting: NONE
Please note: If selecting this setting, a possibly necessary emergency stop can only be triggered with the
white key of the multiZENTRALE
3.4.3 "DELAY"
This is used to set the delay with which items 3.4.1 and 3.4.2 are activated.
"IMMEDIATELY": No time delay.
▪
"1": Use the arrow keys to set the time delay.
▪
Value range: 1–255 seconds and IMMEDIATELY
Factory setting: IMMEDIATELY
Confirm with "Light /OK." You are returned to the "DELAY" start level.
▪
3.5 "NFOS"
This menu item provides detail information about the software version ("SOFTWARE"), the Mac address
("MAC ADDR"), the RocoNet type ("X–BUS"), the "CENTRE" assigned to the multiMAUS
MODULE."
Information about the current power consumption of the central controller ("CURRENT CENTRE", value shown
as mA) and the current voltage value of the batteries or rechargeable batteries ("BATTERY VOLTAGE", value-
shown as mV) are practical for users.
Use an arrow key to view the desired information. Press the "Light /OK" key to return to the previous level.
3.6 "RADIO"
3.6.1 "CONNECT"
Your multiMAUS
take your multiMAUS
your handheld unit must be paired again with the central controller at the new location. This is ac-
complished with this subitem.
The pairing procedure, however, differs only slightly from the steps described on pages 3 and 49.
After pressing "Light /OK", the scrolling text "PRESS BUTTON ON CENTRE FOR 3 SEC" appears.
▪
Press the key labeled "Connect" within 30 seconds and keep pressed for at least 3 seconds. The
▪
yellow and red LEDs light up. The multiMAUS
as running lights. Either "LOCO 1" (when using the multiMAUS
last used locomotive or locomotive address is displayed.
Since the track voltage is shut off during the pairing process, the yellow LED at the central
▪
controller lights up and the "STOP" symbol on the display flashes. Simply press the "STOP"
key of the multiMAUS
LED of the multiZENTRALE
the handheld unit.
when the wireless signal has been interrupted!
PRO
usually must be paired only once with your multiZENTRALE
PRO
to a different system also equipped with a multiZENTRALE
PRO
to switch to drive mode and start running trains. The left green
PRO
lights up and stays lit, the wireless symbol appears in the display of
PRO
is outside of the reception range of the multiZENT-
PRO
switches off.
PRO
restarts once all four LEDs are depicted
PRO
PRO
, and the "RADIO
PRO
. If you wish to
PRO
, for example,
PRO
for the first time) or the
77