Routes; Creating A New Route - Roco multiZENTRALEPRO Manuel

2.7 Routes

The multiMAUS
PRO
turnouts into one route and switch together by pressing only one key. A route is a distance covered by a train
crossing several turnouts. For example, this can be used to move a freight train from a feeder track across sever
turnouts switched with a single command and onto the main track without interruption.
Use the multiMAUS
to embed a route into another route, i. e. one route cannot be combined with another route.
Train operation is not suspended or canceled while in route mode! This is also why the display depicts the
drive symbols. The last active locomotive is also possible with the drive controller and an emergency stop
can also be triggered.
The turnout switching action and whether the train has already passed across the route usually does not
trigger a confirmation.

2.7.1 Creating a New Route

Input
/
62
62
does not only offer the possibility to switch individual turnouts but can also combine several
to configure 64 routes each with a maximum of 16 turnouts. However, it is not possible
PRO
Display message Comment
Press the "Loco/Turnout" key. The last
selected turnout is displayed, in this case
turnout 24.
Press "Shift" and "Loco/Turnout" at the
same time to open route mode.
The image depicted to the left is shown if
there are no routes created yet.
If there are already some created routes, use
the arrow keys to find the available storage
slot marked with "NEW?".
Confirm by pressing "OK".
Now enter the name of the route, in this
case "NSR" for "north–south route". Five
characters can be entered.
Entry is the same as creating a locomotive
in the library (see page 54).
Confirm by pressing "OK".