Overview Of Functions; Carriage Settings; Address - Roco CV29 Manuel D'utilisation

F-key Function
Light** Carriage tail light
F03* Carriage doors corridor side
GB
F04* Carriage doors
compartment side
F07 Interior carriage lighting
LED-non-flicker
F16 Conductor's whistle
F17 Conductor's announcement
in german language
F18** Carriage tail light stop
ON: Tail light NEVER on
OFF: control via F0
*) For mechanical reasons, the doors of a carriage can only permit the position `open´ on one long side
(`corridor´ or `compartment´)!
**) All information concerning the tail light only has validity if your carriage is fitted with a fixed tail
light.
If you wish to programme other decoders (e.g. in the locomotive, carriage, etc.), you must remove
the carriage with the revolving door from the track as this will otherwise also be programmed.

Address

The carriage is programmed at address 3 in the delivery state.
The carriage can be programmed at diverse addresses between 1-99 via CV1. 9999 addresses are possible
via the long addressing (CV17/18) (this requires the activation of an additional CV29 Bit5, see CV list).
If your carriage has a tail light, this is logically coupled to only one locomotive (direction of
travel, activation) if both of the addresses are the same.
16
8045868921.indd 16

Overview of functions

Function Type
ON/OFF
OPEN/CLOSE
OPEN/CLOSE
ON/OFF
ON/OFF

Carriage settings

Direction- Additional
related sound





01.02.2010 13:51:36