Roco multiZENTRALEPRO Manuel page 55

Display message Input Comment
Confirm by pressing "OK."
The multiMAUS then switches to the
PRO
+
/
locomotive address. The "suggested value"
is displayed, in this case "3."
or
Change the suggested value by either using
the "shift" key and one of the "arrow keys"
or by entering the number directly using the
"function keys". This change only affects the
library name order! You must change the
decoder address using CV1 (see chapter
2.8, page 64).
If the locomotive address you selected is
already assigned, the scrolling text „LOCO
ADDRESS ALREADY ASSIGNED" is dis-
played. If this is the case, you must select
a different value.
Confirm by pressing "OK."
You select the � Speed steps using the
/
"arrow keys". You have 3 options available.
14, 28 or 128 speed steps. The factory setting
is for 128 speed steps. If you have selected
a preset in the "SETTINGS" menu, this will
appear on the display screen.
With 128 speed steps you can control your
locomotive with a particularly high level of
sensitivity. Modern decoders give you the
option of fine control.
If you do not wish to make a change, simply
press "OK."
When you press the "OK" key for the final
time, you are finished entering the locomo-
tive in the library. Just check whether the
locomotive address in the library is iden-
tical to the address saved in the locomo-
tive decoder. Re-program the locomotive
address as necessary (see chapter 2.8, page
64). The locomotive can now be controlled.
55