Multizentrale Pro : Important Leds; Multimaus Pro : The Display Screen - Roco multiZENTRALEPRO Manuel

1.2 multiZENTRALE
Your new multiZENTRALE
tant functions of your ROCO digital system. You should place the control center where you can easily see the LEDs.
Green: If the green LED (all the way to the left) lights up, a wireless con-
nection has been established with the multiMAUS
Yellow: The multiZENTRALE
LED lights up if you are programming a locomotive on a con-
nected programming track.
Press the "STOP" key or switch the multiMAUS
low LED flashes.
Red: The red LED indicates a malfunction. It flashes rapidly in case of a short circuit and overload. The LED
lights up permanently if the multiZENTRALE
Green: The green LED (on the very right) flashes briefly if the control center is switched on. The LED flashes longer
once the power consumption increases.
Please read the detailed description of the multiZENTRALE
1.3 multiMAUS
All the functions of the multiMAUS
Drive symbols
Arrows shows the direction of travel of
▪
the selected locomotive
"II" denotes that the locomotive is at
▪
a standstill (by controller or selected
emergency stop)
Battery symbol
Not visible: Everything OK
▪
Visible: Battery/rechargeable
▪
battery voltage drop
Flashes: Replace batteries
▪
Short circuit
the symbol flashes in the
▪
event of a short circuit
or an overload
Stop (stop key)
the symbol flashes in the
▪
event of an emergency stop
or short circuit
Shift-Symbol
is shown as confirma-
▪
tion of the shift key
50
50
: Important LEDs
PRO
is equipped with LED indicator lights that provide a quick overview over the most impor-
PRO
automatically switches and the yellow
PRO
: The Display Screen
PRO
can be checked on the large LCD with backlight. The symbols are as follows:
PRO
Wrench
The multiMAUS
▪
the "SETTINGS" menu
level
ABC
MENU
lights up when text
▪ ▪
is being entered
.
PRO
off and the yel-
PRO
switches off due to an ongoing overload.
PRO
in the fourth part starting on page 80.
PRO
Turnout symbol
is in (locomotive /turnout key)
PRO
▪
▪
Wireless symbol
▪
Locomotive symbol
(locomotive /turnout key)
▪
▪
Light symbol (Light /OK key)
▪
Function symbols (1 –10)
▪
▪
Prog
lights up as a confirmation when
the multiMAUS is
PRO
▪
programming and in the
in the menu level
"PRO GRAM" menu level
Turnout or route mode
Menu level: Route menu
This symbol provides
information about the
wireless connection with the
multiZENTRALE
PRO
Drive- or turnout mode
with "MENU": "LOCO" menu
locomotive light switched on
display the currently activated
special locomotive functions
showing sub-item ranks in the
menu level