Power Supply; Safety Devices - GYS GYSDUCTION AUTO Mode D'emploi

Translation of the original instructions
• These Class A devices are not intended to be used on a residential site where the elec-
tric current is supplied by the public network, with a low voltage power supply. There
may be potential difficulties in ensuring electromagnetic compatibility on these sites,
because of the interferences, as well as radio frequencies.
• This hardware is compliant with the IEC 61000-3-12.
• This equipment complies with the IEC 61000-3-11.
Maintenance:
• If the power cable is damaged, it must be replaced by the manufacturer, its after sales
service or an equally qualified person to prevent danger.
• Warning! Always disconnect from the mains before performing maintenance on the
device.
• High Voltage and Currents inside the machine.
• Remove the casing on a regular basis, to remove any excess dust. Take this opportu-
nity to have the electrical connections checked by a qualified person, with an insula-
ted tool.
• Do not use solvents or any agressive cleaning products.
Regulations:
• Device complies with europeans directives.
• The certificate of compliance is available on our website.
• EAC Conformity marking (Eurasian Economic Community).
• Equipment in conformity with Moroccan standards.
• The declaration C‫( م‬CMIM) of conformity is available on our website (see cover page).
Waste management:
• This product should be disposed of at an appropriate recycling facility. Do not throw
away in a domestic bin.
• Equipment in compliance with British requirements. The British Declaration of Confor-
mity is available on our website (see home page).
•This product should be recycled appropriately.
IDENTIFICATION
On the back of the product is the following information:
• Manufacturer's name and address
• Model
• Product serial number
• Operating voltage
• Product power
Model and serial numbermust be mentioned each time a technician intervention is required or if spare parts are
requested.

POWER SUPPLY

The GYSDUCTION is fitted with a 16A socket type CEE7/7 which must be connected to a single-phase 230V (50/60 Hz)
power supply fitted with three wires and one earthed neutral.
Check that the power supply and its protection (fuse and/or circuit breaker) are compatible with the current needed by
the machine. The product is protected for operation on a generator.

SAFETY DEVICES

• The product has the safety feature PROTEC 400. It is protected against overvoltage above 300V and against neutral
disconnection.
GYSDUCTION AUTO EN
15