Product Description; Automatic Mode - GYS GYSDUCTION AUTO Mode D'emploi

Translation of the original instructions
• During intensive use, the inductor, cables, electronics and power transformer heat up. In order to avoid dysfunction
due to overheating, the Gysduction is equipped with an air cooling circuit. A thermal protection also switches off the
product when the internal temperature becomes too high.
• The inductors are insulated to protect the user against possible electric shock..
• The Gysduction is equipped with a safety device against accidental heating. If the heating control is inadvertently
activated (pressure on the control pedal or glass inductor control button), and the inductor is not in contact with the
metal to be heated for a time exceeding one minute, then the unit will beep and switch off automatically. Release
the heater control to go back to a normal heating cycle.

PRODUCT DESCRIPTION

Gysduction is made up of an inductor connected to an alternating medium-frequency power source. When a heating
control is switched on, a strong magnetic field is emitted by the inductor. When approaching a ferrous metal, the induc-
ted currents will create heating in the metal, without physical contact.
Gysduction Auto can be used for many applications (depending on the selected inductor):
- to remove all logos, adhesives, mouldings, plastic rods glued to bodywork.
- unbolt and unlock metal parts (bolts, screws, connecting rods...).
- remove bonded glass (rear glass, rear quarter, panoramic roof).
- Remove rubbing strips and seals.
The product will heat steel, but is not suitable for heating Aluminum, copper or zinc.
OPERATING INSTRUCTIONS
2
1
10
No-Load

Automatic mode

To start this mode:
16
GYSDUCTION AUTO
3
4
5
7
8
9
If there is no part to be heated, or if the inductor is placed on a non-ferrous
metal, the « no-load »indicator (10) lights up when pressure is applied on one
of the heating controls.
With this mode, Gysduction adapts to suit the part to be heated (size-thick-
ness) and takes into account the distance between the part and the induc-
tor. It maintains a constant and optimal heating power, symbolised by the
OK zone (9) of the interface. With this mode, the GYSduction never heats at
maximum power.
Automatic mode is the default heating mode. If, however, the unit is set to
manual mode, briefly press the MODE button (7) until the LED in front of
"AUTO" (4) lights up.
Display : The digital display shows the last % value used by the machine to maintain
a constant and optimal power according to the heating conditions. This
value corresponds to the settings that should be used in Manual mode to
obtain the same result with the same conditions. Thus, if the user considers
the heating recommended by the Gysduction too low or too high, he can
copy this value in the manual mode and vary it to reach the desired power.
1 Setting controls
2 Digital display
3 Power-on indicator
4 Auto mode indicator
5 Manual mode indicator
6 Max. power indicator
6
7 Selection mode button
8 Thermal protection indicator
9 Optimal heating area
10 «No load» indicator
EN