GYS GYSDUCTION AUTO Mode D'emploi page 19

Translation of the original instructions
10. Once the corner of the pane is released / peeled off, repeat the heating process along the length and height of the
pane while moving the wedges under the pane as you go.
Windows
Front windscreen
Rear window
Quarterlight window
Side windows
Bolt inductor
ref. 053366
Description
The bold inductor is used for intense heating of rusted or seized parts such as nuts and bolts. This inductor can also be
used for removing caulking from truck chassis or car trunks, for welding large connectors or for metal forming.
Use
• To remove a seized or rusted nut / bolt:
1. Choose Auto mode or set the power at a very high level (80 to 100% of power).
2. Place the bolt inductor on the nut as shown.
3. Start the heater and let it run for a few seconds.
4. Loosen the nut or the bolt.
Adhesive inductor
ref. 053359
Description
This inductor is designed to peel off door mouldings / rubbing strips, badges as well as advertising and decorative
adhesives in a few minutes without damage.
GYSDUCTION AUTO
9. Apply pressure from inside the vehicle without breaking the seal.
Once the seal is removed, it will not stick to the metal again.
When the glass corner lifts, slide a plastic wedge into the space left between
the glass and the welded edge. Be careful not to exert too much force that
could break the ice.
Material
Laminated glass
Annealed glass
Glass fragility
+++
+
EN
Removal time
according to vehicle size
20 min to 1 h
10 to 20 min
19