GYS GYSDUCTION AUTO Mode D'emploi page 20

Translation of the original instructions
Use
• For heating painted metal sheets
1. Select Auto mode or set the power to a low level (10 to 30% of its maximum heating capacity).
2. Place the inductor just above the area to be heated. There must be no contact between the inductor and the area
or element to be heated.
3. While activating the heater, make a circular or to-and-fro movement on the area to be heated.
If the inductor stays too long on the same area, the paint may burn. To avoid this, it is necessary to keep the inductor
constantly in motion (back and forth or circular).
•
For peeling off decals, vinyl stickers or glued bars
Some elements that have been glued for a long time often require a longer heating time. If a sticker is overheated, it
often becomes soft and puffy. If this happens, allow to cool and try again to remove and peel the sticker. Be careful not
to burn the paint! If the sheet metal is heated sufficiently, the stickers should peel off easily, taking the glue with them.
• For the removal of mouldings glued to the bodywork
Body side mouldings are removed in the same manner as transfers and stickers. Higher power or longer time is required
for thicker mouldings. The metal under the mouldings is further away from the inductor.
1. Select Auto mode or set the power to a medium level (40 to 60% maximum heating).
2. Place the inductor parallel to the work surface to achieve uniform heat distribution.
3. Favour a back and forth movement along the length of the moulding. Start with one end of the moulding. Slowly
move back and forth a few centimetres until the end of the moulding can be removed effortlessly.
4.Then slowly move the inductor further along the molding while detaching the molding from the body.
The tape is usually removed with the moulding. If adhesive or tape remains stuck to the body, then advance more slowly
or increase power.
• For heating body parts
In winter or in regions with cold climates, the body of a car to which transfers, stickers or beads are to be affixed
must be preheated in the workshop to allow the adhesives to adhere.
1. Set the power at low level (10 to 30% of its maximum heating capacity)
2. Use circular or back and forth movements on the area to be preheated.
Paintless dent pulling
inductor
ref. 054776
Description
The dent pulling inductor has been designed for paintless dent repairs on car bodies, made by hail impacts for example.
The heating is from the outside and the heat is very limited.
20
GYSDUCTION AUTO
Carry out the three steps described above (see to heat the pain-
ted sheets). Heat for a few seconds and try to lift one edge of
the element. If it starts to peel off easily upwards, the required
temperature has been reached, otherwise continue heating for
a few more seconds and try again.
EN