Power Supply - GYS STARTIUM 330E Mode D'emploi

Translation of the original instructions

POWER SUPPLY

Check that the power supply and its protection (fuses) are compatible with the current required by the machine. The
device must be positioned so that the socket is easily accessible. The machine must be connected to a socket WITH
earth according to the following recommendations:
Mains voltage
Protection
charge
Charging
power
Starting
*In the event that starting a HGV proves difficult , use a 20A plug (optional).
The recommended cross-section for an extension is : 3 x 2,5 mm².
CONNECTION AND DISCONNECTION (cf p.5)
Before any connection
• Before any connection to a vehicle battery, make sure
that the booster isn't connected to the mains and that the
booster's switch is set to OFF.
• Locate the + and - battery terminals. (polarity reversal can
damage the fuse).
• Keep the cables away from hot or sharp surfaces. Separate
the 2 cables properly and avoid pinching them.
• Check that the battery capacity (Ampere hour Ah) and
the voltage (Volt V)are compatible with your charger (see
table above).
12V
Charging
capacity
24V
Connection
1.
2.
3.
4.
STARTIUM 330E / 480E / 680E / 980E
STARTIUM 330E STARTIUM 480E
230V - 1 ph
16 A
800 W
6 500 W
STARTIUM 330E STARTIUM 480E
20 - 375 Ah
20 - 300 Ah
Plug the connector into the «12 V» or «24 V» position of the STARTIUM according to the
battery to be charged or started.
Connect the clamps (several possible cases):
a.
The negative terminal is plugged onto the car's chassis :
- Connect the red clamp to the battery's positive terminal.
- Connect the black clamp to the vehicle's chassis, make sure it is a safe distance from
the battery and the fuel/exhaust pipe.
b.
The positive terminal plugged onto the car chassis, in this event :
- Connect the black clamp to the battery's negative terminal.
- Connect the red clamp to the vehicle's chassis, make sure it is a safe distance from
the battery and the fuel/exhaust pipe.
c. Battery disconnected from the vehicle :
Connect the red clamp to the battery's positive terminal and the black clamp to the
battery's negative terminal.
Connect the device to the mains.
Press the ON / OFF button.
A LED, (8) or (10) switches on under the corresponding interface to confirm the selected
voltage input. If the selected voltage does not match the battery voltage, the charge cannot
start.
STARTIUM 680E
230V - 1 ph 230V - 1 ph
16 A
1 700 W 2 000 W
9 000 W 10 000 W
STARTIUM 680E
20 - 600 Ah 20 - 675 Ah
20 - 450 Ah 20 - 525 Ah
STARTIUM 980E
230V - 1 ph
16 A 16 A*
2 000 W
12 000 W
STARTIUM 980E
20 - 750 Ah
20 - 525 Ah
EN
15