Power Supply - Start Up - GYS TIG 160 DC LIFT Mode D'emploi

Thank you for choosing this machine. To get the best from your machine, please read the following carefully:
The TIG 160 DC LIFT is a portable Inverter welder, for electrode welding (MMA) and TIG Lift in DC. It allows
welding with rutile, basic, stainless steel and cast iron electrodes. It works on a single phase 230V power
supply. In TIG, it will weld most of metals except aluminium and alloys. It is protected for a use on electric
generators (230V /+- 15% or 400V/+-15 %).
POWER SUPPLY – START UP
• This machine is delivered with a 230V socket /16A plug type EEC7/7. The TIG 160 DC must be connected
to a 230 V socket (50-60Hz) EARTHED power supply. The absorbed effective current (I1eff) is indicated
on the machine at maxiumum usage. Check that the power supply and its protection (fuse and/or circuit-
breaker) are compatible with the necessary current needed for use.
to change the plug to allow maximum performance.
always accessible.
• To turn on the machine press ON / STAND BY.
• The device will turn on in protection mode if the power supply voltage is over 265V.
To indicate this fault the screen displays
voltage has returned to within its normal range.
• This class A device is designed to be used in an industrial or professional environment. This equipment is
not intended for use in residential locations where the electrical power is provided by the public low-
voltage supply system.
.
as well as radiation
• This material does not comply with IEC 61000-3-12. If it is to be connected to a low-voltage mains supply,
it is the responsibility of the user to ensure it can be connected. If necessary consult the operator of your
electrical distribution system.
ELECTRODE WELDING (MMA Mode)
• Connect the earth and electrode-holder cables. Respect the polarity indicated on the electrodes'
packaging.
• Apply the usual welding rules.
• Your machine is equipped with 3 specific functions :
(adjustable mode, see below) increases the current at the beginning of the welding.
Hot Start
increases the current in order to avoid sticking when the electrode enters the weld pool.
Arc Force
Anti Sticking allows you to easily remove your electrode without damaging it in case of sticking.
Selection of MMA Mode and intensity setting :
- Select the MMA position
- Adjust the desired current (display
Hot Start adjustment
Hot Start is adjustable from 0 to 60% within the limit of 160A.
Advice: low Hot Start: for thin metal sheets – high Hot Start for metals that are difficult to weld (dirty or
oxidized parts).
To adjust the Hot Start follow these steps:
. Normal operation will resume after
It can be difficult to ensure electromagnetic compatibility, due to conducted disturbances
with the selector until the MMA indicator illuminates
) using the key
Press the selector
The "MMA" LED starts flashing and the display indicates the current
Hot Start value.
Set the required percentage ( display
Validate the required figure by pressing the selector button
The "MMA" LED remains illuminated
In some countries, it might be necessary
The welder must be installed so that the main plug is
.
briefly
thirty seconds when the
) using keys
8/20