Quick Commissioning; Storing The Remote Controls; Memorising A 2 Or 4 Button Remote Control; Exit The Programming Mode Without Programming A Remote Control - SOMFY Elixo 800 Manuel D'installation

6. QuiCk CommissioNiNG

6.1. storing the remote controls

To memorise the remote controls, use the PROG button of the
RTS radio module.

6.1.1. memorising a 2 or 4 button remote control

[1]. Press the PROG button of the RTS radio module
(approximately 2 s) until the red indicator lights up
continuously.
[2]. Press the radio control channel to be assigned to the
motor within 2 min. The red indicator will flash, the remote
control is memorised.
If this procedure is carried out using a channel which has
already been memorised, this channel will be cleared.

6.1.2. Exit the programming mode without programming a remote control

Press the PROG button of the control unit briefly.

6.2. Programming the impact force and the slowing zones

This programming step makes it possible to:
- set the impact force of the gate, in case of an impact with an obstacle in the slowing phase,
- define the start point for slowing of the gate when opening and closing.
The slowing point can be excluded.

6.2.1. Before programming

• If the electrical and safety devices (photoelectric cells, orange
light, etc.) must be installed, they must be connected before
programming (see connecting peripherals page 13).
Check that they operate correctly:
- The NC input LED indicators (stop, photoelectric cells,
end limit, safety edge) must be lit.
- The NO input LED indicators (open/close, pedestrian
open) must be off.
In case of a fault, identify the problem and resolve it.
• The REG potentiometer must be positioned between + and -.
• The gate must be opened approximately 50 cm.
Copyright © 2011 Somfy SAS. All rights reserved.
PAUSA PAUSA LAVORO PROG LAVOR A A O PROG
20 20
19 19
START START
18 18
PED PED
STOP STOP
FOTO FOTO
FCA FCA
DL10 DL10
FCC FCC
COSTA COSTA
10 10
9 9
8 8
7 7
6 6
PROG PROG PROG
5 5
4 4
[1]
3 3
2 s
F1 F1
2 2
1 1
PAUSA LAVORO PROG PAUSA LAVOR A A O PROG
20 20
19 19
START
18 18
PED
17 17
16 16
STOP
15 15
FOTO
14 14
13 13 FCA
DL10 DL10
12 12
FCC
11 11
COSTA
10 10
9 9
8 8
7 7
6 6
5 5
4 4
3 3
F1 F1
2 2
1 1
Elixo 800/1300/2000
DL12 DL12
PROG
F2 F2
.......2 min........
DL11 DL11
PROG PROG
[2]
DL12 DL12
PROG PROG
F2 F2
DL11 DL11
11