SOMFY Elixo 800 Manuel D'installation page 41

1. GENEral iNformatioN
The Elixo assembly has been designed for the motorisation of sliding gates up to 800 kg, 1,300 kg or 2,000 kg for residential or
small business use.
assistance
For further information on how to choose, purchase or install Somfy systems, please ask for advice from your Somfy installer
or contact a Somfy advisor directly for help and assistance.
Conformity
Hereby, Somfy, declares that this product is in compliance with the essential requirements and other relevant provisions of
Directive 1999/5/EC. A declaration of conformity is available on the website at www.somfy.com/ce (Elixo 800/1300/2000),
usable in EU, CH and NO.
2. safEty
If installed and used correctly, the motorisation system conforms to required safety standards. It is recommended that these
rules of conduct be respected to prevent the risk of danger or accidents.
Before using the motorisation system, read the user guide carefully and keep it for future reference.
Keep children, people and objects out of the motorisation operating range, particularly during operation.
Do not leave radio controls or other control devices within easy reach of children, to prevent unintentional operation of the motor.
Do not deliberately prevent the gate from moving.
Do not attempt to open the gate manually if the actuator has not been unlocked with the special release handle.
Do not modify the motor components.
In the event of incorrect operation, switch off the power supply, activate the emergency release to enable access and request
assistance from a qualified technician (installer).
For all external cleaning operations, switch off the power supply and at least one of the battery terminals (if present).
Never clean the motor with high pressure water cleaning equipment.
Clean the photoelectric cell optical units. Ensure that branches or shrubs do not obstruct the safety equipment (photoelectric
cells).
For all direct operations on the motor, please contact a qualified technician (installer).
Have the motor checked every year by a qualified technician.
3. oPEratioN
operation in sequential mode (4 steps)
operation in semiautomatic mode (3 steps)
operation with photoelectric cells
The photoelectric cell operation mode can be programmed during installation, as follows:
• Photoelectric cell mode activated for closing only: if an obstacle is detected when closing, the gate stops then reopens.
• Photoelectric cell mode activated for opening and closing:
- when opening: if an obstacle is detected, the gate will stop and then continue to open when the obstacle no longer obstructs the
cells.
- when closing: if an obstacle is detected, the gate will stop and then reopen when the obstacle no longer obstructs the cells.
Operation with orange flashing light
The orange light is activated during any movement of the gate. A 3 second pre-warning signal before movement starts may be
programmed during installation.
Copyright © 2011 Somfy SAS. All rights reserved.
STOP
STOP
Elixo 800/1300/2000
1