Installation Of Cable Grommets; Aerial Wiring; Motor Connections; Power Supply Wiring - SOMFY Elixo 800 Manuel D'installation

Elixo 800/1300/2000

5.2. installation of cable grommets

Make small holes in the cable grommets, so that each
grommet has a firm grip of the cable.
If the grommets do not grip the cables, insects can enter
and cause short circuits, causing irreversible damage to the
electronic logic.

5.3. aerial wiring

For optimum reception, the aerial:
- must be as far as possible from the supply terminals and
wires
- must always be installed at a height and must be visible
from a distance.
- must not be cut
- must not be fixed to a metal post or behind a grille.
The mounting plate is an active component of the aerial. It
must not be removed or modified.
Cut the coaxial cable if it is too long. Shortening the cable will
improve the signal (a coaxial cable which is too long, extended
or connected with an insulating screw joint will distort the
signal).

5.4. motor connections

Check the connections depending on whether the motor (viewed from inside) is positioned to the right (factory configuration) or to the left.
motor connection
End limit connection
A

5.5. Power supply wiring

PoWEr suPPly
CÂBLE
CaBlE
ALIMENTATION
230v~
230 V~
switch on the power to the installation before commissioning.
10
motor to the left (a)
Wire Terminal
Open 7
Close 6
Brown 13
Black 14
Blue 11
5 mm
a
b
15 mm
motor to the right (B)
Terminal
6
7
14
13
11
B
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
22
21
Earth MASSE
aErial
ANTENNE
Copyright © 2011 Somfy SAS. All rights reserved.