Cleaning And Maintenance; General; Before Or After Each Trip - Conrad REELY Deathwatcher EVO BL Notice D'emploi

12.

Cleaning and maintenance

a) General
Before cleaning or maintenance, the speed controller must be turned off and the drive battery must be completely
disconnected from the speed controller. If you have previously driven the vehicle, allow first for all parts (e.g. motor,
speed controller etc.) to cool off completely.
After driving, clean the entire vehicle of dust and dirt, using, for example, a long-haired clean brush and a vacuum
cleaner. Compressed air sprays can be helpful as well.
Do not use any cleaning sprays or conventional household cleaners. By doing this, electronics might be damaged;
also, such means lead to discolouring of the plastic parts or the vehicle body.
Never wash the vehicle with water, for example, using a high pressure cleaner. As a result, the motor, speed controller
and receiver will get ruined. The vehicle must not become damp or wet!
To wipe the vehicle body use a soft, slightly damp cloth. Avoid rubbing firmly; otherwise there will be scratch marks.
b) Before or after each trip
Due to motor vibrations and shocks when driving, parts and bolted joints can loosen.
Therefore, before and after each trip check the following positions:
• Tight fit of wheel nuts and of all bolted joints of the vehicle
• Fastening of speed controller, on/off switch, receiver
• Bonding of the tires on the rims or tires' condition
• Fastening of all cables (these must not get into the moving parts of the vehicle)
Before and after each use, check as well the vehicle for damages. If you notice any damage, the vehicle
must not be used or operated.
If worn-out vehicle components (e.g. tires) or defective vehicle parts (e.g. a broken transversal arm) must be
replaced, use only original spare parts.
56