Conrad REELY Deathwatcher EVO BL Notice D'emploi page 45

When switching between forward and backward driving, the throttle/brake lever must be briefly (about 1 second) in the
neutral position (neutral position = release lever, do not move it). If the throttle/brake lever is pulled straight, without
pausing, from forward to backward driving, the braking function of the drive (the vehicle does NOT move backward)
occurs.
When the drive battery is empty, be sure to wait at least 5 - 10 minutes, until the motor and the speed controller have
cooled down sufficiently. Start a new drive only with a fully charged drive battery.
The following images are only for illustration purposes of the functions; they do not need to coincide with the
design of the supplied transmitter.
1. Release the gas/brake lever, the vehicle rolls out (or does not move; if necessary, correct the trimming), lever is in
neutral position
2. Drive forward, slowly pull the throttle/brake lever towards the handle

3. Drive forward and then stop (vehicle decelerates; does not roll out slowly), push the gas/brake lever away from
the handle, without pausing

4. Drive forward and backward (between the shift wait a few seconds (approximately 1 - 2 seconds) and put the
throttle/brake lever in the neutral position!)

Wait briefly
45