Setting Fit-To-Page; Setting Paper Tray; Setting The Destination Bin - HP LaserJet MFP Analog Fax Accessory 300 Guide

Setting Fit-to-page

When selecting a page size to print a fax, the MFP determines the
closest page size that matches the intended size from sizes available
in the MFP. If the fit-to-page setting is enabled and the received
image is larger then that page size, the MFP attempts to scale the
image to fit the page. If this setting is disabled, an incoming image
larger than the page, splits across pages.
To enable or disable fit-to-page, perform the following steps.
1
2
3
4
5

Setting paper tray

The paper tray setting selects the MFP paper tray to pull paper from
for printing faxes.
To select the paper tray, perform the following steps.
1
2
3
4
5

Setting the destination bin

The destination bin setting specifies the MFP output bin to receive the
printed fax.
To set the destination bin, perform the following steps.
1
2
3
ENWW
On the control panel, press the Menu button to display the main
menu.
Touch FAX to display the fax menu.
Scroll down and touch FAX RECEIVE.
Touch FIT TO PAGE to display the fit-to-page settings.
Touch ON to enable fit-to-page, or touch OFF (default) to disable
fit-to-page.
On the control panel, press the Menu button to display the main
menu.
Touch FAX to display the fax menu.
Scroll down and touch FAX RECEIVE.
Touch FAX PAPER TRAY to display the settings screen.
Use the up and down arrows to select the number for the tray
(default=0), and then touch OK.
On the control panel, press the Menu button to display the
main menu.
Touch FAX to display the fax menu.
Scroll down and touch FAX RECEIVE.
Setting Fit-to-page 43