Setting Outgoing Fax Resolution; Setting The Overlay Header (Outgoing Faxes) - HP LaserJet MFP Analog Fax Accessory 300 Guide

Setting outgoing fax resolution

The outgoing fax resolution setting determines the maximum
resolution supported by the receiving fax. The fax accessory uses
the highest possible resolution, limited by this setting, and the
maximum resolution of the receiving fax.
Faxes wider than 21.25 cm (8.5 inches), will automatically be sent using
Note
standard or fine, to reduce phone time.
To set the resolution, perform the following steps.
1
2
3
4
5
The higher the resolution, the longer the transmission time required.
Note

Setting the overlay header (outgoing faxes)

The overlay header consists of the date, time, company name, phone
number, and page number and is printed at the top of the page on
outgoing faxes. This setting determines whether the header is
appended to the top of the page or is printed as an overlay. If the
header is appended to the top of a page, it moves page data down
which can result in data at the bottom of a page being pushed to
another page, possibly printing an additional page. If the header is
printed as an overlay, it does not push any page data, but may print
over data at the top of the page.
When fax forwarding is enabled, the overlay header is always
Note
appended to the top of the page, even if overlay is enabled.
To select how the header is printed, perform the following steps.
1
2
3
38 Chapter 3 Configuration
On the control panel, press the Menu button to display the main
menu.
Touch FAX to display the fax menu.
Scroll down and touch FAX SEND.
Touch DEFAULT RESOLUTION to display the resolution
settings.
Touch STANDARD (200 x 100 dpi), FINE (200 x 200 dpi;
default), or SUPERFINE (300 x 300 dpi) to select the resolution.
On the control panel, press the Menu button to display the
main menu.
Touch FAX to display the fax menu.
Scroll down and touch FAX SEND.
ENWW