Installing/Replacing The Fax Accessory In The; Hp Laserjet 4345Mfp - HP LaserJet MFP Analog Fax Accessory 300 Guide

Making cabling connections to the formatter for the HP LaserJet
Figure 1-6
9040/9050mfp
11 Connect the other end of the phone cord into the phone jack on
12 Plug in the MFP AC power cord and set the power switch to on.
This completes the installation of the fax card. Next, you need to
verify that the fax has been installed correctly and is operating, see,
"Verifying fax operation" on page 11.

Installing/replacing the fax accessory in the

HP LaserJet 4345mfp

This procedure provides information on how to install the fax card in
the HP LaserJet 4345mfp.
The fax card is installed on the MFP formatter board, which is
accessed by removing a MFP side panel. To install the fax card,
complete the following steps.
1
2
3
ENWW
the wall. Push the connector in until it "clicks."
Unpack the fax card from the box, but do not remove it from its
antistatic pouch.
Set the MFP's power switch to off and disconnect the AC power
cord.
Locate the formatter board (1) on the back of the printer, see
Figure 1-7.
LAN Cable (if used)
Phone cord
Installing the fax accessory 7