Parts Included With The Fax Accessory; Installing The Fax Accessory - HP LaserJet MFP Analog Fax Accessory 300 Guide

If the MFP did not come with the fax accessory installed, you need to
Note
install it as described in this chapter. If the MFP came with the fax
accessory installed, you need to connect the phone cord and perform
the initial fax configuration, also described in this chapter.

Parts included with the fax accessory

The following components are included with the fax accessory:
HP LaserJet MFP Analog Fax Accessory 300 contents
Figure 1-1

Installing the fax accessory

This section describes installing the hardware fax accessory card into
the MFP. Procedures are provided for:
Select the procedure for your MFP.
The HP LaserJet MFP Analog Fax Accessory 300 is also supported
in the HP LaserJet 9500mfp, however, the fax accessory is
pre-installed in the HP LaserJet 9500mfp. For information about
installing or replacing the fax accessory in the HP LaserJet 9500mfp,
refer to the HP LaserJet 9500mfp User Guide.
2 Chapter 1 Setting up
Fax guide (this document)
Fax accessory hardware card
Phone cord(s) (cords vary depending on the country/region.)
HP LaserJet 9040/9050mfp
HP LaserJet 4345mfp
ENWW