Warning Messages On The Display - VOLTCRAFT B6 Notice D'emploi

17. Warning messages on the display

REVERSE POLARITY REVERSE POLARITY
REVERSE POLARITY REVERSE POLARITY REVERSE POLARITY
CONNECTION BREAK CONNECTION BREAK CONNECTION BREAK
CONNECTION BREAK CONNECTION BREAK
SHORT ERR SHORT ERR SHORT ERR
SHORT ERR SHORT ERR
INPUT VOL ERR INPUT VOL ERR
INPUT VOL ERR INPUT VOL ERR INPUT VOL ERR
VOL SELECT ERR VOL SELECT ERR
VOL SELECT ERR VOL SELECT ERR VOL SELECT ERR
BREAK DOWN BREAK DOWN
BREAK DOWN BREAK DOWN BREAK DOWN
BATTERY CHECK BATTERY CHECK BATTERY CHECK
BATTERY CHECK BATTERY CHECK
LOW VOLTAGE LOW VOLTAGE
LOW VOLTAGE LOW VOLTAGE LOW VOLTAGE
BATTERY CHECK BATTERY CHECK BATTERY CHECK
BATTERY CHECK BATTERY CHECK
HIGH VOLTAGE HIGH VOLTAGE
HIGH VOLTAGE
HIGH VOLTAGE HIGH VOLTAGE
BATTERY VOLTAGE BATTERY VOLTAGE BATTERY VOLTAGE
BATTERY VOLTAGE BATTERY VOLTAGE
CELL LOW VOL CELL LOW VOL
CELL LOW VOL CELL LOW VOL CELL LOW VOL
The polarity of the accumulator poles has been
switched.
The connection to the accumulator has been
broken, e.g. if the accumulator has been
disconnected during the charging process.
A short-circuit has been established on the charger
output.
The input voltage (operating voltage) for the
charger is too low.
The voltage of a LiPo, LiIon, LiFe accumulator to
be charged is incorrectly configured.
The charger has established that there is an internal
problem. Should this message permanently be
displayed, it is possible that the charger is defective;
have it checked by a specialist workshop or
qualified technician.
During the charging process it has been established
that the accumulator has been totally discharged.
In this case you should check if the voltage of the
accumulator has been correctly set for the charging
process.
The voltage in one of the cells of a LiPo, LiIon, LiFe
accumulator is too low. This can occur if a multicell
accumulator has been charged previously without
a balancer.
87