Warning Messages On The Display - VOLTCRAFT B6 Quadro Notice D'emploi

16. Warning Messages on the Display

The polarity of the battery connections has been switched.
The connection to the battery has been disrupted, e.g. if the battery
was disconnected during the charging process.
A short-circuit has been identified on the charger output.
The input voltage (operating voltage) for the charger is too low.
The voltage of a LiPo, LiIon, LiFe battery to be charged has been
incorrectly configured.
The charger has identified an internal problem. Should this message
be displayed permanently, it is possible that the charger is faulty; have
it checked by a specialist workshop or qualified technician.
During the charging process it was identified that the battery is totally
discharged.
In this case you should check if the voltage of the battery has been
correctly set for the charging process.
The voltage in one of the cells of a lithium battery (LiPo, LiIon, LiFe) is
too low. This can occur if a multi-cell battery was previously charged
without a balancer.
The voltage in one of the cells of a lithium battery (LiPo, LiIon, LiFe) is
too high. This can occur if a multi-cell battery was previously charged
without a balancer.
69